Digiair Pro DVB-T Aerial TV Terrestrial Meter

The new Emitor´s DIGIAIR Pro DVB-T is developed in Sweden for exact alignment and adjustment of terrestrial antennas. This is made for both analogue (dBuV) and digital (BER and SNR). DIGIAIR Pro is microprocessor controlled, making it very reliable and accurate.

Signal strength is presented on the LCD-display. In analogue mode it shows a single channel or six channels at the same time. You can also choose to view the signal in spectrum mode. In digital mode it displays the BER (bit error rate) and SNR (signal/noise ratio). Readout of UCB (uncorrected bits) and CB (corrected blocks) is also easy to do.
Furthermore DIGIAIR Pro present pitchtones (the higher tone the stronger signal) on a loudspeaker. DIGIAIR Pro is very sensitive and can detect even the weakest signals.

Digiair Pro leaflet

Digiair Pro user manual

DIGIAIR Pro can feed Voltage (5/12 Volt) to external active antennas this feature is short-circuit protected by an automatic fuse.

DIGIAIR Pro is charged via an external DC power-source of 13,5 -18 volt.

The DIGIAIR Pro operates with 8xAA rechargeable batteries. The unit will works for at least 2 hours with fully charged batteries.

Even though the DIGIAIR Pro has a lot of functions it is still very easy to use and has a very compact design.

 Features:

    Perfect for digital terrestrial installations (COFDM)
    Frequency range of 45-860MHz
    Easy digital readout of BER and SNR
    Very sensitive, easy to maximize weak and strong signals
    Analogue signal level reads out in dBuV
    Presents one channel readout with high resolution or six
    channels simultaneously or the complete spectrum
    Built in beeper (pitch tone) and maxhold function
    Aerial power output, 0V, 5V, 12V and 24V
    Built in, rechargeable battery
    Power supply and car-charger enclosed
    Carrying-case enclosed
    Small and handy design
    Made in Sweden

Technical specification:

    Input frequency: 45-860 MHz.
    Input level:  30-80 dBuV.
    Input impedance:  75 Ohm, F-connector.
    Short circuit protection:  Automatic fuse on antenna input.
    Measuring method:  in digital Two bars showing BER (bit error rate)   and SNR (Signal/noise ratio)
    in Analog: One bar showing dBuV in high resolution or 6 bars showing strength of 6 channels. Spectrum display. Pitch tone beeper
    Signal-level readout: digital BER and SNR values.
    analogue: dBuV with maxhold-function.
    Power out: 0V, 5V,12V and 24V on/off.
    Power supply/charger: 10 -18V DC (Centerpin +).
    Display: Back-lighted 128x64 Pixels LCD.
    Power consumption: 500mA.
    Battery: 8x AA rechargeable batteries of 1200mA each.
    Weight: 0.3 kg.
    Dimensions: 185 x 115 x 50 mm.

Accessories:

Power supply 12V DC, 1A, Rubber-case, Car charger.

The unit will works for at least 2 hours with fully charged batteries.